Nannycare Goat Stage 1 First Infant Milk (0-6 Months) (800g)

Pasteurised goat whole milk, lactose (from milk), vegetable oil blend (high oleic sunflower oil, rapeseed oil, sunflower oil, antioxidants (sunflower lecithin, tocopherol-rich extract)), pasteurised goat milk powders, oil from the microalgae Schizochytrium sp., 2'-fucosyllactose (from milk), Mortierella alpina oil, calcium citrate, choline chloride, sodium citrate, L-tyrosine, calcium hydroxide, L-tryptophan, L-cystine, L-isoleucine, taurine, ferrous sulphate, dl-α-tocopheryl acetate, L-ascorbic acid, zinc sulphate, potassium chloride, inositol, nicotinamide, cholecalciferol, retinyl acetate, L-carnitine. calcium d-pantothenate, cyanocobalamin, copper sulphate, phytonadione, thiamine hydrochloride, riboflavin, pyridoxine hydrochloride, manganese sulphate, folic acid, potassium iodide, sodium selenite, d-biotin

Allergy Advice: For allergens, see ingredients in bold. This product contains 38% goat milk on a dry matter basis.

Typical values per 100ml prepared feed

Energy: 270kJ/66kcal

Fat: 3.4g
of which, saturates: 1.2g
of which, mono-unsaturates: 1.6g
of which, polyunsaturates: 0.53g
- linoleic acid (omega 6): 0.4g
- α-linolenic acid (omega 3): 0.053g
- docosahexaenoic acid (DHA): 0.015g
- arachidonic acid (AA): 0.016g

Carbohydrate: 7.3g
of which, sugars (lactose): 7.3g

Fibre: 0.10g
of which, 2'-fucosyllactose (2'-FL): 0.10g

Protein: 1.3g

Vitamins
Vitamin A: 56µg
Vitamin D3: 1.4µg
Vitamin E: 1.5mg
Vitamin K1: 6.7µg
Vitamin C: 12mg
Thiamin (B1): 0.062mg
Riboflavin (B2): 0.12mg
Niacin (B3): 0.66mg
Vitamin B6: 0.036mg
Folate: 22µg DFE
Vitamin B12: 0.18µg
Biotin: 2.3µg
Pantothenic acid: 0.35mg

Minerals
Sodium: 19mg
Potassium: 70mg
Chloride: 57mg
Calcium: 63mg
Phosphorus: 39mg
Magnesium: 4.6mg
Iron: 0.65mg
Zinc: 0.49mg
Copper: 0.049mg
Manganese: 0.0090mg
Fluoride: 0.0065mg
Selenium: 2.5µg
Iodine: 13µg

Others
Choline: 21mg
Taurine: 4.6mg
Carnitine: 0.90mg
Inositol: 3.9mg

How to Prepare Your Baby’s Milk

Because powdered milk is not sterile, failure to follow these instructions may make your baby ill.

Step 1: Wash and sterilise

Wash your hands thoroughly. Sterilise all bottles, teats, and utensils according to the manufacturer’s instructions.

Step 2: Prepare the water and milk powder

Boil 1 litre of freshly run water and allow it to cool for no longer than 30 minutes. Measure the required amount of water into a sterilised bottle (refer to the feeding guide).

Using the scoop provided, add the correct number of level scoops of powder. Use the built-in leveller—do not press or heap the powder. Do not use artificially softened or repeatedly boiled water.

Step 3: Mix, cool, and feed

Place the sterilised teat and cap on the bottle. Hold the bottle horizontally and shake left to right for 10 seconds, then hold it vertically and shake up and down for another 10 seconds.

Cool the bottle under running tap water, check the temperature, and feed immediately.

Important Feeding Instructions

Use only the 4.3g scoop provided. Always add one level scoop of powder (4.3g) to each 30ml of cooled, boiled water. For hygiene reasons, do not store made up feeds. Use feeds within 2 hours at most. Always use freshly boiled and cooled water. Always discard unfinished feeds. Make up each feed as required.  Do not heat in a microwave as hot spots may occur and cause scalding. Do not add extra scoops of powder, or anything else to your baby’s feed. Do not leave your child alone during feeding.