Nestlé NAN SUPREMEpro 3 Growing Up Milk (1-3 Years) (400g)

Lactose, vegetable oils [high oleic sunflower oil, low erucic rapeseed oil, sunflower oil, arachidonic acid (from Mortierella alpina oil)], whey protein isolate (from cow's milk), whey protein concentrate (from cow's milk), docosahexaenoic acid (from tuna fish), emulsifier (soy lecithin), L-arginine, acidity regulator (citric acid), 2'-fucosyllactose, lacto-N-tetraose, 3'-sialyllactose, 6'-sialyllactose, difucosyllactose, antioxidants (mixed tocopherol concentrate, L-ascorbyl palmitate), bifidus culture, L-histidine, L-tyrosine, VITAMINS (vitamin C, pantothenic acid, niacin, vitamin E, vitamin B2, vitamin B1, vitamin A, vitamin B6, folic acid, vitamin K, biotin, vitamin D, vitamin B12), MINERALS (calcium phosphate, calcium glycerophosphate, potassium chloride, magnesium chloride, calcium chloride, ferrous sulfate, zinc sulfate, copper sulfate, manganese sulfate, potassium iodide, sodium selenate).Allergy Advice: Contains milk, soy, and fish (DHA source).

Typical values per 100ml prepared feed

Energy: 67kcal

Protein: 1.27g

Fat: 3.18g

Linoleic Acid: 0.48g

Alpha-Linolenic Acid: 0.04g

Arachidonic Acid (ARA): 16.82mg

Docosahexaenoic Acid (DHA): 16.82mg

Trans Fatty Acids: 0.03g

Carbohydrate: 8.36g

Lactose: 8.32g

2'-Fucosyllactose: 0.021g

Difucosyllactose: 0.003g

Lacto-N-tetraose: 0.007g

6'-Sialyllactose: 0.005g

3'-Sialyllactose: 0.005g

Vitamin A: 57.4mcg RE

Vitamin D: 1.5mcg

Vitamin E: 1.03mg TE

Vitamin K: 5.06mcg

Vitamin C: 9.57mg

Vitamin B1: 0.07mg

Vitamin B2: 0.15mg

Niacin: 0.63mg

Vitamin B6: 0.05mg

Note: source table was cut off after Vitamin B6 — folate, B12, biotin, pantothenic acid, and the full mineral panel (sodium, potassium, calcium, phosphorus, iron, zinc, iodine, selenium etc.) should be confirmed against the tin before publishing.

How to Prepare Your Baby's Formula

Because powdered formula is not sterile, failure to follow these steps correctly may make your baby ill.

Step 1: Wash your hands thoroughly and sterilise all bottles, teats and utensils before use.

Step 2: Boil fresh drinking water and let it cool to approximately 40°C (do not let it cool for more than 30 minutes). Pour the required amount of water into the sterilised bottle first.

Step 3: Using the scoop provided, add the correct number of level scoops of powder for the water volume (refer to the feeding table on the pack) — do not pack or heap the scoop.

Step 4: Cap the bottle and shake or swirl until fully dissolved. Cool to feeding temperature by holding under cool running water, test the temperature, and feed immediately. Discard any unused formula within 1 hour of preparation.