Nannycare Goat Stage 3 Toddler Milk (1-3 Years) (800g)

Pasteurised whole goat milk, lactose (from milk), vegetable oil blend (high oleic sunflower oil, rapeseed oil, sunflower oil, antioxidants (sunflower lecithin, tocopherol-rich extract)), pasteurised goat milk powders, oil from the microalgae Schizochytrium sp., calcium citrate, 2'-fucosyllactose (from milk), choline chloride, dicalcium phosphate, sodium citrate, L-tyrosine, calcium hydroxide, L-cystine, L-isoleucine, ferrous sulphate, taurine, dl-α-tocopheryl acetate, L-ascorbic acid, zinc sulphate, potassium chloride, inositol, nicotinamide, cholecalciferol, retinyl acetate, L-carnitine, calcium d-pantothenate, cyanocobalamin, copper sulphate, phytonadione, thiamin hydrochloride, riboflavin, pyridoxine hydrochloride, manganese sulphate, folic acid, potassium iodide, sodium selenite, d-biotin.

Allergy Advice: For allergens, see ingredients in bold. This product contains 38% goat milk on a dry matter basis.

Typical values per 100ml prepared feed

Energy: 250kJ/59kcal

Fat: 3.1g
of which, saturates: 1.1g
of which, mono-unsaturates: 1.5g
of which, polyunsaturates: 0.48g
- linoleic acid (omega 6): 0.36g
- α-linolenic acid (omega 3): 0.048g
- docosahexaenoic acid (DHA): 0.014g

Carbohydrate: 6.7g
of which, sugars (lactose): 6.7g

Fibre: 0.027g
of which, 2'-fucosyllactose (2'-FL): 0.027g

Protein: 1.2g

Vitamins
Vitamin A: 50µg
Vitamin D3: 1.5µg
Vitamin E: 1.4mg
Vitamin K1: 6.1µg
Vitamin C: 6.8mg
Thiamin (B1): 0.062mg
Riboflavin (B2): 0.11mg
Niacin (B3): 0.59mg
Folic Acid: 20µg DFE
Vitamin B12: 0.16µg
Biotin: 2.1µg
Pantothenic acid: 0.31mg

Minerals
Chloride: 51mg
Calcium: 59mg
Phosphorus: 42mg
Iron: 0.90mg
Zinc: 0.44mg
Copper: 0.044mg
Selenium: 2.2µg
Iodine: 12µg

How to Prepare Your Baby’s Milk

Because powdered milk is not sterile, failure to follow these instructions may make your baby ill.

Step 1: Wash and sterilise

Wash your hands thoroughly. Sterilise all bottles, teats, and utensils according to the manufacturer’s instructions.

Step 2: Prepare the water and milk powder

Boil 1 litre of freshly run water and allow it to cool for no longer than 30 minutes. Measure the required amount of water into a sterilised bottle (refer to the feeding guide).

Using the scoop provided, add the correct number of level scoops of powder. Use the built-in leveller—do not press or heap the powder. Do not use artificially softened or repeatedly boiled water.

Step 3: Mix, cool, and feed

Place the sterilised teat and cap on the bottle. Hold the bottle horizontally and shake left to right for 10 seconds, then hold it vertically and shake up and down for another 10 seconds.

Cool the bottle under running tap water, check the temperature, and feed immediately.

Important Feeding Instructions

Use only the 4.3g scoop provided. Always add one level scoop of powder (4.3g) to each 30ml of cooled, boiled water. For hygiene reasons, do not store made up feeds. Use feeds within 2 hours at most. Always use freshly boiled and cooled water. Always discard unfinished feeds. Make up each feed as required.  Do not heat in a microwave as hot spots may occur and cause scalding. Do not add extra scoops of powder, or anything else to your baby’s feed. Do not leave your child alone during feeding.